RE Analyst Project

RE Analyst is selected by clicking the RE Analyst tab on the EMI Analyst Main form.  The RE Analyst form, shown in the figure below, is the main user interface when performing radiated emissions analyses. 

If RE Analyst is the only EMI Analyst application installed the RE Analyst form will open when EMI Analyst is started.  If applications in the EMI Analyst suite, other than RE Analyst are installed, for example CE Analyst, the RE Analyst form is opened by selecting the RE Analyst tab.

The buttons across the upper-middle of the form open modules that allow the radiated emissions analysis to be configured to simulate the circuit under investigation.  A graph beneath each status bar summarizes the results from that module.  There is no summary graph for the Frequency module.  The diagram that covers the bottom half of the form illustrates the configuration of the circuit under analysis.

When a new RE Analyst project is initiated the status bars beneath each button on the RE Analyst form are red, the summary graphs are not present, and the configuration diagram is shown as a gray outline.  A red status bar indicates that that module has not been completed.  As each module is completed the status bar is changed to green.  Simultaneously the corresponding summary graph is displayed and the portion of the configuration diagram for that module is converted from gray outline to gradient color, as in the figure above.  Modules are completed by clicking the module button on the RE Analyst form, entering values on the module form, and performing applicable calculations. When the module form is closed the program returns to the RE Analyst form. 

More:

RE Model